4 Pack Ignition Coils and Iridium Spark Plugs for Subaru Outback 2010-2012 2.5L

4pcs Ignition Coils+ 4pcs Iridium Spark Plug for 2010-2012 Subaru Outback  UF668+7092

 

Feature:

Connector: 3 Pins
Connector Gender: Female
Terminal Gender: Male
Terminal Type: Blade
Voltage: 12V

Thread Diameter: M14

Thread Length: 19MM

 

Specifications

• Brand New Ignition Coil           

• Built to strict quality control standards.     

• Ready to use, Direct Replacement.

• 100% Compatible with OEM Parts, meets Original Equipment Manufacturer (OEM) Standards

• 100% pure copper windings in bobbins improve durability ,thermoplastic housing withstands heat stress for enhanced durability

• Silicone rubber boot withstands extreme heat to ensure superior insulation

 

Warranty: 1 Year

Package including: 4pcs Ignition Coil + 4pcs Iridium Spark Plug

If you have any questions, please contact us first and we will solve it for you. Thank you for your kindness！

NOTE: 

• Installation Manual Is NOT Included.
• Professional Installation Is Highly Recommended.
• Please check the part number on your old part housing before purchase.
• please confirm the item if it matches your car before you purchase.
• We only sell BRAND NEW parts, unless otherwise stated.

 

Part Number or OEM Number:
Replace for :

Ignition Coil: UF668, UF-668, 22433AA620, 22433AA621, 7092, BKR6EGP

Spark Plugs: 7092

 

 

Compatible Vehicle(for reference only):

Fit For

2010-2012 Legacy H4 2.5L

2010-2012 Outback H4 2.5L

 

 

How to Change Ignition Coils and Spark Plugs?

 

This product recommends professional installation.

 

1. Disconnect the old ignition coil and spark plugs

 

2. Disconnect your battery’s negative terminal

 

3. Locate the ignition coil and spark plugs to be replaced.

 

4. Release the clip on the plug running into the side of coil.

 

5. Use a wrench to unscrew the bolts holding the original coil in place

 

6. Extract original ignition coil and spark plugs from the engine bay

 

7. Swapping in the new ignition coil and spark plugs

 

8. Prior to installation, compare the new coil to the old one

 

9. Orient the new coil in the same direction

 

10. Insert the bolts to hold the coil in place

 

11. Activate the New ignition coil and spark plugs

 

12. Connect the plug into the side coil

 

13. Plug in ignition cables according to the order written on them.

 

14. Reconnect the battery

 

15. Start the vehicle to test the new ignition coil and spark plugs

 

 

Note:

 

1. In preparation for the replacement, the vehicle should be turned off and cooled for a certain period of time before starting the replacement.

 

2. Pay attention to the cleanliness of the entire operation, must wipe the ignition coil around the dust and oil, if into the combustion chamber, will have serious adverse effects, try to wear gloves to operate.